Meni se svidja sto podrzava i MAV link protokol.
OSD mu je prva liga.
http://www.myflydream.com/download/MFD_AP_en.pdfOSD display will slightly change base on the fly modes
A. Fly time
B. Flight modes,Has 6 modes including MAN/STB/WPT/CIR/RTH,about 6 flight mode
details (please refer to chapter 8.Test flight)
C. Heading, Heading to the north is 0 degree. East south and west are 90,180,270. When
the airplane’s speed is greater than 5km/h. the heading data comes from the GPS. When
the speed is less than 5Km/H, the heading data comes from the combination of GPS and
internal compass.
D. GPS available satellites.
E. RSSI,receiver signal strength.
F. Ground speed,unit: km/h.
G. Altitude,unit: meter. Data comes from barometer.
H. Home direction indicator (In waypoint navigation mode the indicator will point to the
current waypoint direction, In CIR circle mode the indicator points to the center) when
the indicator points to the 12 o’clock direction, it means the target is in front of the
airplane. When the indicator points to 9 o’clock direction, it means the target is on the
left side of the plane.
I. Airplane icon. Always on the center of the display. Simulate the airplane when you
looking from the tail of the airplane. Using this icon with the Artificial horizon calculates
by the AP will give you a clear view of the airplane attitude. If the icon is above the
AHL(artificial horizon line) means the airplane is climbing, otherwise is diving.
J. Artificial horizon line, AP calculates the current attitude and simulates a horizon line on
the screen.
K. Target azimuth. Only applies for CIR, WPT and RTL. Indicates where the target is (home,
waypoint, circle point) based on the airplane position, if this number is 0, it means the
target is north of the airplane.
L. Target altitude. It only shows when the AP is in CIR,WPT or RTH modes. It means that
the AP is flying to this altitude.
M. Battery voltage, this data is from the 100A current sensor. The gauge shows the
percentage of the battery left. To get more accuracy showing on the gauge, you have to
setup the battery type (SENSORS SETTINGS->BATTERY TYPE). The AP will assume that
4.2v is the voltage of a fully charged of battery cell. And 3.7v means the battery cell is
empty. If you don’t want to show this gauge, set the battery type = 0S in the OSD menu.
N. Current, Data is from the 0~100A current sensor.
O. Battery consuming. Unit: mah.
P. Home distance. Unit: meter.
Q. Roll angle.
R. Pitch angle. You can also select to display GPS coordinates here instead of Roll & Pitch.
S. Throttle percentage. The longer the vertical line means more throttle is applied.
T. Climbing rate. Full length as the altitude bar indicates a 4m/s climbing rate.
if the climbing rate is greater than 4, it will show up a precise number at the end. (as
shown in the below picture, the climbing rate = 5.7m/s)