svaki put kad otvorim tvoj thread vidim i info da je izasao novi fw
daj nam link
Stavio na HEX thread, no mogu i tu.
link
http://www.rcgroups.com/forums/showpost.php?p=23209042&postcount=6371Izasao 1.5 s gimball kontrol
Here is version 1.5 with roll/pitch camera stabilization.
Roll servo goes to output 7 and pitch servo to output 8.
Turn it on by going to "Cam Stab Settings" screen and set the gains to a non-zero value. Start with 500. A negative value reverses servo direction. Adjust value until camera is steady.
Use the offset values to trim servo position, but keep the values close to 50% by adjusting servo linkage first.
Now I have to say that I have not tested this with an actual camera, but it should work.
This version will reset all settings to default due to changes in EEPROM usage.